3 Switch off the host system and connect up your MaxiScan 2200
Dual RS-232 C
terminal
dual RS-232 cable
The default hardware configuration of the MaxiScan 2200
transmits data on the DTE connector (to host) only.
1. Switch off the host system.
2. Disconnect the terminal from the host system.
3. Use the dual RS-232 cable to connect the MaxiScan 2200 between the terminal
and the host system.
Do not switch on the host system.
4. Connect the power supply to the dual RS-232 cable.
5. Plug the power supply into the mains socket.
14
serial port
Õ
Í
terminal
DCE
serial port
Ö
host system
Î
DTE
host
power supply
MaxiScan 2200 - Installation Guide