Intermec MaxiScan 2200 Installation Manual page 103

H If you have a problem . . .
This appendix describes things you can check if you have problems with your MaxiScan 2200 during
power-up, configuration and normal operation.
If you can not solve the problem yourself, please contact your Intermec representative.
Check the following points
General setup problems
U
correct MaxiScan 2200 model for your host system—check the number of
orange indicator LED flashes at power-up
U
correct cables / external power supply if required
U
MaxiScan 2200 connected up correctly
U
system switched on—sufficient electrical power
U
correct interface number selected for your MaxiScan 2200 model and host
system
U
correct power-up beep indication—2 beeps
U
indicator LED shows green after power-up—orange indicates that no interface
number is selected
U
End Selection scanned once, twice or three times when required for certain
configuration codes
General operating problems
U
MaxiScan 2200 in standby mode—present a bar code to activate
U
correct symbologies selected for the codes you are trying to read
U
all unnecessary symbologies disabled
U
symbologies you read are available for your MaxiScan 2200 model
U
good reading distance for the reading situation
U
good resolution adjustment (video channel) for the type of codes you read
U
good scan rate for the type of codes you read
U
barcode length compatible with MaxiScan 2200 minimum length / fixed length
parameter settings
U
barcode quality—damaged or poorly printed codes, "fragile" symbologies
U
MaxiScan 2200 configured for check digit and no check digit present in code
MaxiScan 2200 - Installation Guide 103