Intermec MaxiScan 2200 Installation Manual page 104

H If you have a problem . . .
Before you contact your Intermec representative . . .
If you do not find a solution after checking the above points, you can try a general
reset of the MaxiScan 2200.
1. Switch off the electrical supply to the MaxiScan 2200—switch off the host system
or disconnect the MaxiScan 2200.
2. Position the Reset Factory Defaults code (Appendix G) in front of the MaxiScan
2200 and provide electrical power—switch on the host system or reconnect the
MaxiScan 2200.
3. Finish the general reset procedure as described in Resetting the factory default
settings in Appendix G.
If you still have a problem . . .
Contact your Intermec representative with full details of the problem.
Your Intermec representative may ask you to provide the software version number
for your MaxiScan 2200. If the MaxiScan 2200 is powered up, try to read the
following code to display this information on your host system screen if applicable.
104
Software Version
MaxiScan 2200 - Installation Guide