Intermec EasyCoder PL4 User Manual page 56

Printer Problems (continued)
Symptom
The printer is not
communicating with
the network.
The printer does not
print POP3 e-mail
messages.
56
Solution
Print a configuration label to check the
following settings:
•
eSSID
•
Operating mode
•
Preamble length
•
IP address
•
Network mask
•
Gateway
•
Encryption
•
Authentication
•
LPD
•
TCP
•
TCP/UDP port
Check with your network administrator to
make sure that the previous settings are
configured correctly for your network. For
help printing a configuration label, see
"Verifying the Printer Is Working" earlier in
this guide. For help configuring the printer for
your network, see "Establishing
Communications With a Terminal" earlier in
this guide.
On the configuration label, make sure "Card
Detected" appears in the PCMCIA/CF
Adapter section. If "Card Not Detected"
appears, contact your Intermec technical
support representative.
Make sure that the printer is within range of
the access point.
Make sure the printer is correctly configured
for your POP3 settings. For help, see "Setting
Up for POP3 E-mail Printing" earlier in this
guide. For help getting the POP3 settings
from the printer, see the EasyCoder PL-Series
Printer Programmer's Reference Manual.
EasyCoder PL4 Printer User's Guide