Intermec EasyCoder PL4 User Manual page 36

! U1 SETVAR "ip.gateway" "xxx.xxx.xxx.xxx"
! U1 SETVAR "ip.addr" "xxx.xxx.xxx.xxx"
where "xxx.xxx.xxx.xxx" will be replaced with valid values for
your network. If you are unsure what values to enter, please
contact your network administrator for assistance.
6 Turn the printer off and on.
7
Test the configuration. For help, see the next procedure.
To test that the printer is ready for LPD or TCP printing
1
Print a configuration label. For help, see "Verifying the
Printer Is Working" earlier in this guide.
2
Ping the IP address of the printer and verify
acknowledgement (from a DOS prompt on Windows
platforms).
3 Print a test label via Intermec PLUS. Test using TCP sockets
(port 6101) and LPD.
Setting Up WEP Encryption
PL4 printer
Before setting up the printer, you need to know the WEP key
that your wireless network is using. If 40-bit encryption is
enabled, the key is 10 hexadecimal (0 to 9, A to F) characters;
otherwise, if 128-bit encryption is enabled, the key is 26
hexadecimal characters.
36
Host
Access
point
Laptop PC
EasyCoder PL4 Printer User's Guide
P L 4 U 0 5 1 . e p s