Loading Fanfold Media - Intermec EasyCoder PL4 User Manual

PL4U046 .eps
4
Rotate the latch assembly until it locks in place.

Loading Fanfold Media

The PL4 has a loading slot in the rear of the media
compartment that allows you to use standard 101.6-mm
(4-inch) wide fanfold media from an external supply. It is
important to place the external media supply in a location that
allows the media to feed easily through the printer.
To load fanfold media
1
Press the latch release button on the side of the printer. The
latch assembly flips open automatically.
2
Rotate the media cover back to expose the media
compartment and the adjustable media supports.
3
Pull the media supports apart, insert a media spacer such as a
label roll core or other cardboard tube between them, and let
the media supports close.
4 Insert the media from the external supply through the rear
feed slot, between the media guides, and up through the
media compartment. Make sure the side of the media you will
be printing on faces the printhead.
EasyCoder PL4 Printer User's Guide
Self-strip
bar
Latch
assembly
21