Wireless Local Area Network (Wlan) Communications - Intermec EasyCoder PL4 User Manual

11
Close the Bluetooth print utility, or print another label.

Wireless Local Area Network (WLAN) Communications

This section provides information about the Compact Flash
radio and PCMCIA card radio and procedures for the following
setup scenarios:
• LPD and TCP printing
• WEP encryption
• POP3 e-mail printing
• Ad Hoc mode
WLAN Module Using a Compact Flash Radio
Note: The following section only applies when the CF
(Compact Flash) WLAN module is installed in the PL4
printer. The FCC ID number label is on the bottom of the
printer.
Use of the PL4 with the CF radio module meets the FCC
requirements for radio frequency radiation exposure when
worn in the standard configuration. In this configuration,
which applies whether you use the belt clip or shoulder
strap, the face of the printer where the media comes out is
facing away from you. You must use the standard
configuration when wearing the printer.
Avertissement: L'utilisation du PL4 avec le module radio
CF est conforme aux exigences de la FCC en termes
d'irradiation à la radiofréquence lorsque porté selon la
configuration standard. Sous cette configuration, qui
s'applique selon que vous portiez une pince de ceinture ou
une courroie, le côté de l'imprimante d'où sort le support
ne fait pas face à l'utilisateur. Il faut utiliser la
configuration standard lors du port de l'imprimante.
Printers equipped for WLAN communications use the industry
standard 802.11b protocols. These printers allow wireless
communication as a node within a LAN, and its wireless
capabilities allow communications from any point within the
32 EasyCoder PL4 Printer User's Guide