Loading Fanfold Media - Intermec EasyCoder 4420 User Manual

EasyCoder 4420 and 4440 Bar Code Label Printer User's Manual
C d
9 Release the lower media guide and adjust the edge guide (by loosening it
and sliding it) to position the media firmly against the inside wall of the
printer.
10 Adjust the label gap sensor position if necessary. For help, see
"Adjusting the Label Gap Sensor" in Chapter 5.
11 If you are using thermal transfer media, you need to load ribbon. Follow
the instructions for "Loading Thermal Transfer Ribbon" later in this
chapter before you finish performing this procedure.
12 Lower the printhead by rotating the head lift lever counterclockwise
until it locks.
13 If you are loading continuous media or mark label stock, use PrintSet,
your third-party software, or the printer command set to tell the printer
what kind of media you are using.
14 Press the Feed/Pause button to advance several inches of media through
the printer and out the label opening in the front cover. The yellow
Empty/Pause LED goes out.
Note: If the yellow Empty/Pause LED does not go out, reload the media
and try again.
Note: In the future, you may want to refer to the label located on the
inside of the media cover for directions on loading media.

Loading Fanfold Media

In fanfold printing, you place a stack of fanfold media at the rear of the
printer and feed it into the printer through a slot in the rear cover.
To load fanfold media
1 Open the printer.
2 Rotate the head lift lever clockwise to release the printhead.
3 Turn the supply roll retainer counterclockwise and slide it to the outer
end of the supply roll post. See the next illustration.
39
Helvetica CondenseChapter 1 — Getting Started
9