Cleaning The Module - Keysight M5200A Startup Manual

2 Setting up the M5200A module
Section 2.4: Cleaning the module
WARNING
46
Do not attempt to clean the card. If cleaning is absolutely necessary, to
prevent electrical shock, disconnect the power cord from the mains
before removing the modules from the chassis.
1 Power off the chassis and remove the M5200A module.
2 Use either a dry lint free cloth, or compressed air to clean the front
plate (face-plate) only of the M5200A module.
3 If a damp cloth is used, or if there is condensation from the compressed
air, make sure that the card is completely dry before reinserting the
card into the chassis.
M5200A PXIe Digitizer Modules Startup Guide