Printing The Error Log - Intermec EasyCoder 3400d User Manual

Printing the error log

A buffer in the twinax interface called the error log stores the last 20 recorded
errors. When more than 20 error messages accumulate, the first error message
stored is deleted and the new message is added. The accumulated errors report
the occurrence of bad commands received over the twinax system cable, errors
communicating with the printer, or errors the twinax interface encounters while
executing its own code.
Printing the contents of the error log may help you troubleshoot problems by
showing you where to look for errors. However, if you cannot determine the
cause of the problem, call for service.
To print and interpret the contents of the error log:
1. Record the setting of the twinax interface rear panel switches; you need to
2. Without switching off the printer power, set switches 5 through 7 to the ON
Print error log switch settings
know how to set the switches after testing is complete.
position as shown in the figure below. At this point, the printer ignores
incoming messages from the host.
LIN E
ON
T
UL
FA
O
I
O
Twinax Interface
E
LIN
ON
T
FA UL
O
I
ON
T
OFF
TWIN-10
31