Twinax Interface
Terminating the twinax cable
When the printer is the last device on the twinax cable, the twinax interface rear
panel slide switch should be set to the terminate position to designate that the
twinax cable ends at the printer. The twinax cable should not be terminated at
the printer when other devices are connected to the host through the twinax
interface. The twinax interface disables the out connector when the slide switch
is set to terminate the twinax cable. The twinax interface is shipped from the
factory with the slide switch in the up position (unterminated).
To terminate the twinax cable at the printer, set the slide switch as shown in the
figure below.
Setting twinax termination
8
IN
TERMINATE
OUT
UNTERMINATED
Twinax Interface
Panel
IN
TERMINATE
OUT
TERMINATED
TWIN-04