Intermec PB2 Supplementary Manual

Li-ion spent consider not does
non-condensing
non-condensing
104°F) to (-4°F 40°C
113°F) to (32°F
140°F) to (-4°F 60°C

Specifications

Wh)
Wh)
in) 0.8 x 1.5 x (2.8
318-040-001)
battery
notice. without change
Caution: This battery pack may ignite, create a chemical burn hazard, explode, or
release toxic materials if mistreated. Do not incinerate, disassemble, or heat above
80°C (176°F). Do not short circuit; may cause burns. Keep away from children. Use
only Intermec charger Models CPS024100240 and EC-556. Use of incorrect charger
may present a risk of fire or explosion.
WASTE BATTERY MUST PROMPTLY BE RECYCLED OR DISPOSED OF
PROPERLY. SEE INSTRUCTIONS.
Proper Disposal of Waste Batteries
Some of the substances necessary for the proper functioning of batteries are considered harmful to the
environment and to human health. It is therefore important that those substances be kept out of the
environment.
You play an important role in the protection of the environment:
1. Keep all waste batteries out of unsorted trash.
2. Dispose of all waste batteries in separate collection for treatment and recycling.
Please contact Intermec for the collection option(s) available in your location.
Marking of the battery:
1. The wheeled-bin symbol indicates the requirement for separate collection of the battery.
2. Two letters shown underneath the wheeled bin indicate the presence of a certain substance:
a. Hg means Mercury is present
b. Cd means Cadmium is present
c. Pb means Lead is present
3. The Moebius loop (chasing arrows) indicates that the battery is recyclable.
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
© 2009 Intermec Technologies
Corporation. All rights reserved.
PB2 and PB3 Battery Instructions
*943-217-003*
P/N 943-217-003
waste. hazardous as batteries
EPA the U.S.A., the In Note:
85% to 45% humidity:
85% to 45% humidity:
to -20°C temperature:
45°C to 0°C temperature:
to -20°C temperature:
Humidity and Temperature
mAh 2200
(16.28 V 7.4 output:
x
(16.28 V 7.4 output:
x
Specifications Output and
oz) (3.9 g 110
cm 2.1 x 3.8 x 7.1 Dimensions:
(Model
Li-ion Intermec
Specifications
to subject are specifications
Specifications
CONTAINS LITHIUM-ION BATTERY.
disposal,
if distributor
safety applicable
battery.
center
the
Storage
Operating
Storage
from away
Charging
Operating
the into objects
Capacity:
Nominal
or shred, puncture,
Maximum
Capacity
damage
Weight:
such
maximum
to (32°F
Product:
battery. or
Physical
this of Use
and Design
Using This Battery
This lithium-ion battery (Model 318-040-001) is designed for use in
these printers:
y PB2 Mobile Printer
y PB3 Mobile Printer

Charging the Battery

Before using your printer, you need to fully charge the battery. Batteries
can be charged after a partial discharge without affecting the original
battery capacity.
You can charge this battery:
y installed in the printer with the printer AC adapter/charger
(Model CPS024100240).
y in the 2-bay battery charger (Model EC-556).
Use only these Intermec-approved charging accessories. For more
information, see the printer user's guide.
tape. insulating electrical with
Before hazard. safety a
available.
or representative sales Intermec
with accordance in tested
318-040-001 Model another
service Intermec an to it send
that suspect you If printer. the
battery. the to pressure or shocks
connector battery the Keep battery.
water.
contacts. battery
foreign insert to attempt
deform, or bend crush,
. supervised be should
may this as sunlight, direct in
(140°F), 60°C above temperatures
(73°F). 23°C
For range. this outside packs
40°C to 0°C is batteries charging
device the to damage in result
methods. charging approved
Recommendations
PB2 and PB3 Battery
Instructions
connector battery the cover
create may batteries Discarded
longer no is battery this
your Contact standards.
been have batteries These
with only battery Replace
inspection. for
damaged, is printer or battery
or battery the dropping Avoid
mechanical apply not Do
items. metallic
the circuit short not Do
in battery the immerse not Do
the to directly solder not Do
battery.
or battery the modify not Do
burn.
open, or disassemble not Do
children by usage Battery
battery. the
or day hot a on car a inside as
at battery the store not Do
at batteries charge life, battery
battery charge not Do 104°F).
for range temperature The
could devices other in battery
for Battery" the "Charging See
use. before battery the Charge
Important
y
y
y
y
y
y
y
y
y
y
y
y
y
y