Bar Code Field - Intermec EasyCoder 301 Programmer's Manual

4. Bar Code Field

Note:
Complex bar codes, such as PDF
417 and MaxiCode, must be
specified by means of an extended
version of the BARSET com-
mand, see chapter 9.1.
Intermec EasyCoder 301 Direct Protocol 2.0 – Programmer's Guide Ed. 3
As standard, Intermec Direct Protocol supports 38 of the most com-
mon bar code symbologies. Each bar code (optionally including its
human readable interpretation) makes up a bar code field.
In addition to the general formatting commands, PRPOS, ALIGN
and DIR (see chapter 4.2), a bar code field can specify the follow-
ing properties:
• Bar Code Type
• Height (height of bar pattern)
• Ratio (wide bars/narrow bars)
• Magnification (bar pattern)
• Bar Code Interpretation On/Off
• Bar Code Interpretation Font
• Bar Code Interpretation Font Size
• Bar Code Interpretation Font Slant
Select a Bar Code Type
The type of bar code is specified by a BARTYPE command con-
taining an abbreviation of the bar code name. The abbreviation must
be entered exactly as listed below.
BARTYPE | BT "<bar code name abbreviation>"
<bar code name...> the designation of the bar code type accord-
Default:
Reset to default by:
Bar Code
Codabar
Code 11
Code 16K
Code 39
Code 39 full ASCII
Code 39 w. checksum
Code 49
Code 93
Code 128
DUN-14/16
EAN-8
EAN-13
EAN-128
Five-Character Supplemental Code
Industrial 2 of 5
Industrial 2 of 5 w. checksum
Chapter 4
ing to the list below; it must be enclosed by
double quotation marks.
"INT2OF5"
PRINTFEED|PF
Label Design
Abbreviation
"CODABAR"
"CODE11"
"CODE16K"
"CODE39"
"CODE39A"
"CODE39C"
"CODE49"
"CODE93"
"CODE128"
"DUN"
"EAN8"
"EAN13"
"EAN128"
"ADDON5"
"C2OF5IND"
"C2OF5INDC"
23