Intermec EasyCoder 301 Programmer's Manual page 107

1. Commands (Alphabetical), cont'd.
Instruction
FONTS
FORMAT
FORMAT DATE$
FORMAT INPUT
FORMAT TIME$
FORMFEED (FF)
FRE
FUNCTEST$
HEAD
IMAGE LOAD
IMAGES
INPUT ON
INPUT OFF
INVIMAGE (II)
KILL
LAYOUT END
LAYOUT INPUT
LAYOUT RUN
LTS& ON/OFF
MAG
MAP
Intermec EasyCoder 301 Direct Protocol 2.0 – Programmer's Guide Ed. 3
Chapter Purpose
8.1 Returns the names of all fonts stored in the printer's memory to
the standard OUT channel.
6.9 Formats the printer's RAM memory, or formats a RAM-type
memory card to MS-DOS format.
6.4 Specifies the format of the string returned by DATE$("F")
and DATEADD$(...,"F") commands.
6.5 Specifies separators for layout variable data entry.
6.4 Specifies the format of the string returned by TIME$("F")
and TIMEADD$(...,"F") commands.
5.1 Activates the paper feed mechanism in order to feed out or pull
back a certain length of the paper web. If the feed length is not
specified, the printer feeds a blank label.
8.1 Returns the number of free bytes in the printer's RAM memory.
7.3, 7.4 Performs various hardware tests on the ROM, RAM, any cards
fitted and on the printhead.
7.4 Returns the result of a printhead check and sets printhead
resistance.
8.5 Receives and stores image files in .PCX format either in the file
system or in volatile memory.
8.1 Returns the names of all images stored in the printer's memory
to the standard OUT channel.
6.1 Sets SYSVAR(18) to 0 and enables layouts and use of variable
data fields.
6.1 Restores SYSVAR(18) and disables layouts and use of variable
data fields.
4.3, 4.5 Inverts the printing of text and images from "black-on-white"
to "white-on-black.
8.2 Deletes a file from the printer's RAM memory or from a DOS-
formatted memory card.
4.8 Stops the recording of a layout description and saves the layout.
4.8 Starts the recording of a layout description.
4.9 Enables a pre-defined layout.
6.7 Enables or disables the label taken sensor.
4.3, 4.5 Magnifies a font, barfont or image up to four times separately
with regard to height and width.
6.10 Changes the ASCII value of a character when received on the
standard IN channel, or optionally on another specified
communication channel.
Chapter 13 Commands and Functions
106