Label Length; Gap Length; Media Light Transmission - Intermec EasyCoder 301 Programmer's Manual

9. Label Length

10. Gap Length

11. Media Light
Transmission
Intermec EasyCoder 301 Direct Protocol 2.0 – Programmer's Guide Ed. 3
The presently set label length, as specified by the printer's setup
(print window), is returned by the following instruction:
? SYSVAR (<parameter>)
<parameter> = 2
The actual label length, as measured and set by a TESTFEED com-
mand , is returned by the following instruction:
? SYSVAR (<parameter>)
<parameter> = 100 returns label length in dots
Note that the SYSVAR (2) value must be equal to or exceed the
SYSVAR (100) value, or the labels will be truncated.
The presently set label gap length, as set by a TESTFEED com-
mand, is returned by the following instruction:
? SYSVAR (<parameter>)
<parameter> = 101 returns label gap length in dots
The light transmission of the media in the LSS is returned by the
following instruction as a value in the range 0–31, where 0 is maxi-
mum reflection/transmission and 31 is no reflection/transmision. It
can be used to assess the translucency of labels and backing paper
and also has the side-effect of waiting until the motor stops.
? SYSVAR (<parameter>)
<parameter> = 1
Chapter 7 Reading the Printer's Status
returns label length in dots
returns the light transmission value
62