5 Installing and Connecting the WP-121
illustrates the installation and connection of the WP-121.
Figure 5
5.1 Installing the WP-121
To install the WP-121 as illustrated in the example in
1. Connect either the:
Terminal block line output of the WP-121 to the pre-installed STP wiring
in the wall box opening that connects to the TP receiver
—or—
RJ-45 line output of the WP-121 to the pre-installed STP wiring in the
wall box opening that connects to the TP receiver
2. Recommended—ground the wall plate (see
3. Connect the 12V DC power supply to the power terminal block
that the polarity is correct.
4. Insert the WP-121 into the wall box opening and secure the WP-121 front
panel using the screws.
1 Connect the wire labeled "+" to the +12V pin, and the wire labeled "–" to the GND pin
6
Installing and Connecting the WP-121
Figure 5: Installing and Connecting the WP-121
Figure
5:
Section
5.3).
KRAMER: SIMPLE CREATIVE TECHNOLOGY
1
taking care