Connecting Ext3-C-Wp-Xr-T - Kramer EXT3-C-WP-XR-T User Manual

Connecting EXT3-C-WP-XR-T

This section provides instructions for connecting the
compatible receiver (for example, Kramer EXT3-POE-XR-R).
Switch off and disconnect the power to each device before connecting them. After connecting
your devices, connect their power and power-up each device.
In the example in
hosted via the transmitter's USB-C port
port is inactive.
To connect EXT3-C-WP-XR-T to EXT3-POE-XR-R as illustrated in the example in
Figure 4:
1. If required, set to active HOST via DIP-switch 2 (see
on page 11).
By default,
Either the
defined as the active USB host.
2. Connect the HDBT OUT port
IN port on the
3. On the EXT3-C-WP-XR-T
•
Connect a USB-C source (for example, a laptop that supports Display Port Alternate
Mode) to the USB-C IN connector
•
Connect an HDMI LOOP connector
5. On the EXT3-POE-XR-R
acceptor (for example, a smart TV).
EXT3-C-WP-XR-T – Connecting EXT3-C-WP-XR-T
Figure 4: Connecting EXT3-C-WP-XR-T to EXT3-POE-XR-R
Figure 4, the connected USB devices, such as the mic or soundbar, are
EXT3-C-WP-XR-T USB-C port is set active Host.
EXT3-C-WP-XR-T
12
EXT3-POE-XR-R receiver side.
transmitter side:
receiver side, connect the HDMI OUT connector to an HDMI
EXT3-C-WP-XR-T
. In this configuration, the receiver's host USB-B
1
Switch off and disconnect the power to each device befo
your devices,
Defining the DIP-switches
or its compatible receiver (but not both) must be
on the EXT3-C-WP-XR-T
.
1
to an HDMI acceptor.
2
Kramer Electronics Ltd.
transmitter to a
connect their power and power-up each d
transmitter side to the HDBT
9