Connecting The Tp-580Td, Tp-580Rd Dvi Line Transmitter / Receiver - Kramer TP-580TD User Manual

Connecting the TP‑580TD, TP‑
580RD DVI Line Transmitter /
Receiver
Always switch off the power to each device before connecting it to your transmitter and
receiver. After connecting your transmitter and receiver, connect their power and then
switch on the power to each device.
You can use the
configure an DVI transmitter/receiver system, as shown in the example in
Figure 3: Connecting the
To connect the TP‑580TD, TP‑580RD DVI Line Transmitter / Receiver:
1. Connect a DVI source (for example, a Blu-ray player) to the DVI IN connector.
2. Connect the DVI OUT connector to the DVI acceptor, (for example, a display).
3. On the TP‑580TD, connect the RS-232 3-pin terminal block connector to the RS-232
port of a controller device (for example, the Kramer SL-240C).
4. On the TP‑580RD, connect the RS-232 3-pin terminal block to the device to be
controlled, (for example, a display that is controlled by
TP‑580TD).
5. On the TP‑580TD, connect the IR 3.5mm mini jack to an IR emitter that is connected to
the IR-controlled device (for example, a Blu-ray player).
6. On the TP‑580RD, connect the 3.5mm mini jack to an IR sensor.
7. Connect the supplied power adapters to the power sockets of the
TP‑580RD, and plug the adapters into the mains electricity (not shown in
TP‑580TD, TP‑580RD – Connecting the TP‑580TD, TP‑580RD DVI Line Transmitter / Receiver
TP‑580TD DVI Line Transmitter
TP‑580TD, TP‑580RD DVI Line Transmitter / Receiver
and the TP‑580RD DVI Line Receiver
SL-240C which is connected to
TP‑580TD
Kramer Electronics Ltd.
to
Figure 3.
and
Figure 3).
6