Kramer WP-789T Quick Start Manual

Scan for full manual
Step 1: Check what's in the box
WP-789T HDMI 4K Wall-Plate Line Transmitter
1 Power adapter (with open DC head) and cord

Step 2: Get to know your WP-789T

# Feature
HDMI™ IN Connector
1
2 STATUS LED
3 RS-232 (G, Rx, Tx, PROG)
4-pin Terminal Block Connector
4 IR (Rx, Tx-1, Tx-2), 3-pin
Terminal Block Connectors
5 Ring Tongue Terminal
Grounding Screw
6 HDBT OUT RJ-45 Connector
Power Supply 2-pin Terminal
7
Block Connector
WP-789T Quick Start
WP-789T Quick Start Guide
This guide helps you install and use your WP-789T for the first time.
Go to www.kramerav.com/downloads/WP-789T
upgrades are available.
Function
Connects to an HDMI source.
LED Color
Blue
Green
Yellow
White
STATUS LED is off only when the device does not receive power.
Connects to an RS-232 port (see
Connect to an external IR infrared emitter (see
Connect to grounding wire (optional).
Connect to the HDBT IN connector on a receiver (for example, TP-789R).
Connect to a power supply (if required). Connect GND to GND, +12V to +12V.
to download the latest user manual and check if firmware
1 Quick start guide
Frame (or frame set) and faceplate
HDBT Connected Source Detected
Yes Yes
Yes Yes
Yes No
Device is powered with no detected connections.
Step 5: Configure the
P/N: 2 9 0 0 - 3 0 1 0 9 1 QS
Installation accessories
Acceptor Detected
Yes
No
N/A
WP-789T).
Step 5: Configure the WP-789T).
Rev: 2