Table of Contents
Advertisement
5.2 Connecting the Detachable Optical DVI Transmitter/Receiver
To connect the 610T Detachable Optical DVI Transmitter with the 610R
Detachable Optical DVI Receiver, as the example in Figure 4 illustrates, do
the following:
1. Set the EDID of the display device (see section 5.1).
2. Plug the 610T DVI connector directly
3. Connect the 610R to the 5V DC power adapter and connect the adapter to the
mains electricity. The Indication LED is on.
4. Connect the 610R DVI connector directly
device.
5. Connect the duplex LC fiber cables
cable at a time, as illustrated in
610T Transmitter
6. Turn ON the Power on the computer and the display device.
7. If the transmitter does not power up, connect the 5V power adapter
610T transmitter, and connect the adapter to the mains electricity.
8. Set up the screen resolution as required.
1 Do not use any intermediate cable or adapter between them
2 Two duplex LC receptacles connected to two duplex LC patch cord multimode glass of fibers with a 62.5/125µm or a
50/125µm core
3 You can use the power supplied through a DVI pin from the graphic cards instead of using the power adapter. After
completing the installation, if the system does not seem to work properly, reconnect the power adapter while the system is
powered
6
Using the Detachable Optical DVI System
Figure 3
Figure 3: Connecting the Fiber Optic Cables
1
to the DVI connector of the computer.
1
to the DVI connector of the display
2
to the 610T and 610R modules, one
.
KRAMER: SIMPLE CREATIVE TECHNOLOGY
610R Receiver
3
to the
Advertisement
Table of Contents
