6 Capturing the EDID
The EDID can either be captured automatically by the WP-121 transmitter, or you
can set it manually with one of the preconfigured values (see
Figure 9: WP-121 PCB Assembly Front View with Face Plate Removed
#
Feature
1
16 Position Rotary Switch
2
EDID Capture Button
3
EDID Status LED
6.1 Capturing the EDID from a Display Device
To capture the EDID from a display device:
1. Using a Philips screwdriver, remove the four screws holding the faceplate to
the PCB assembly.
2. Using a short cable
WP-121 to the XGA connector of the display and turn the display on.
3. Ensure that the rotary switch (see
small screwdriver to turn it to 0.
1 For example, Kramer model number C-MGM/MGM-1
Capturing the EDID
Table 5: WP-121 PCB Assembly Features
Function
Turn to select the EDID resolution and refresh rate (see
Press to capture the EDID
Flashes slowly when capturing a valid display EDID,
Lights solid when EDID has been successfully captured,
Flashes rapidly when setting a preconfigured EDID
1
, connect the PC IN input 15-pin HD connector on the
Figure
9) is in position 0. If it is not, use a
Table
5).
Table
6)
9