Configuring The Network Parameters For A Udp Plus Network; Checking The Status Of Your Wireless Connection - Intermec CK32 User Manual

Configuring the Network Parameters for a UDP Plus Network

Checking the Status of Your Wireless Connection

CK32 I-Safe Handheld Computer User's Manual
6 Configure security. For help, see See
page 52.
You can configure the network parameters on the CK32 I-Safe to
using Intermec Settings or ISpyWiFi. For information on
Intermec Settings, see
Intermec Settings" on page 40.
In a UDP Plus network, the CK32 I-Safe communicates with a
host computer through the Intermec Application Server. The
Intermec Application Server translates UDP Plus packets on the
wireless network into TCP/IP packets on the wired network and
vice versa. The access point acts as a bridge to allow
communications between the wired network and the wireless
network.
To use w reless commun cat ons n a UDP Plus network
1 Go to Start > Settings > the System tab > Intermec Settings
> Communications >UDP Plus.
2 Configure these network parameters on the CK32 I-Safe:
• UDP Plus Activate
• Controller IP address
• Controller Port
3 Make sure the CK32 I-Safe is talking to the network and that
the network can see the CK32 I-Safe.
4 Configure security. For help, see "Configuring Security on the
CK32 I-Safe" in the next section.
After you configure your wireless settings, you can use iConnect
to check the status of your connection.
To check the status of your w reless connect on
1 Tap the iConnect icon (
Today screen.
2 From the menu, select Status > Wireless. The Wireless Status
screen appears and checks the connection.
Chapter 3 — Configuring the CK32 I-Safe
"Using ISpyWiFi" on
"Configuring the CK32 I-Safe Using
) in the lower right corner of the
51