Configuring The Network Parameters For A Udp Plus Network; Controlling The 802.11 Radio Usage - Intermec CK60 User Manual

Chapter 5 — Network Support
84
To configure the network parameters for a TCP/IP network
1 Configure the network name (SSID), host IP address, IP settings (if not
using DHCP), and network port parameters on each CK60.
2 Configure security. For help, see

Configuring the Network Parameters for a UDP Plus Network

In a UDP Plus network, the CK60 communications with a host computer
through the Intermec Application Server.
The Intermec Application Server translates UDP Plus packets on the
wireless network into TCP/IP packets on the wired network and vice versa.
The access point acts as a bridge to allow communications between the
wired network and the wireless network.
To configure the network parameters for a UDP Plus network
1 Configure the network name (SSID), controller IP address, IP settings
(if not using DHCP), and network port parameters on each CK60.
2 Configure security. For help, see
The easiest way to configure the network parameters on the CK60 is to use
the Intermec Settings applet. For help, see
Applet" on page 10.

Controlling the 802.11 Radio Usage

The CK60 is able to support 802.11 radio usage of either the A-band
(5GHz) or the B/G-band (2.4GHz).
To determine which band your CK60 is supporting
1 Tap Start > Settings > Control Panel, then double-tap the BandEnable
icon.
2 To change the band to enable, select the desired band.
3 Tap ok.
4 Perform a warm-boot for the new setting to take effect.
Your CK60 may be capable of using both bands or just the B/G band. The
BandEnable applet can enable or mask usage of any band the CK60 is
capable of using. The band setting defaults to enable all available bands. At
least one band must be enabled.
"Configuring Security" on page
"Configuring Security" on page
"Using the Intermec Settings
CK60 Mobile Computer with Windows CE User's Manual
93.
93.