Intermec CK32 User Manual page 125

Problems While Operating the CK32 I-Safe
Problem
You press the Power button to turn
on the CK32 I-Safe and nothing
happens.
The Battery light is blinking.
You use your stylus to tap the screen
and nothing happens.
The blue Ready-to-Work indicator
is off.
The blue Ready-to-Work indicator
is blinking.
The blue Ready-to-Work indicator
is on.
CK32 I-Safe Handheld Computer User's Manual
Chapter 5— Troubleshooting and Maintenance
Solutions
Make sure the backlight is on by pressing E.
Make sure you have a charged battery installed correctly.
For help, see "Charging and Installing the Battery" on
page 5.
The battery may be discharged. Replace the battery with a
spare charged battery, or charge the battery and try again.
The battery is running low. Replace the battery with a
spare charged battery, or charge the battery.
Recalibrate your touch screen. For help, see "Using the
Touch Screen" on page 18.
Try these possible solutions:
The Ready-to-Work application (such as TE 2000) has
not loaded successfully. For help, see the documentation
or online help for the application.
The CK32 I-Safe is not running a Ready-to-Work
application.
The Ready-to-Work application (such as TE 2000) may
be running, but is not connected to a host. Verify that the
application is properly configured to communicate with
the host.
A connection has been established, and all network
connections are active. There is nothing to troubleshoot.
109