Configuring 802.11B/G Radio Communications - Intermec CK31G User Manual

Chapter 2 — Configuring the CK31G

Configuring 802.11b/g Radio Communications

34
• Connect the AD1 communications dock to the serial port
of the other device using a DB9 to DB9 serial adapter
cable. Insert the CK31G into the dock.
3 Turn on the CK31G.
Make sure all components with antennas are at least 30 cm
(1 ft) apart when power is applied. Failure to comply could
result in equipment damage.
The wireless CK31G has an internal 802.11b/g radio to transfer
data using wireless communications. This section of the manual
assumes that you have already set up your wireless
communications network including your access points. If you
are using a UDP Plus network, you also need to have your
Intermec Application Server communicating with a host
computer.
Your CK31G supports these network protocols:
• TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CK31G to work in your wireless network.
Configuring the Network Parameters for a TCP/IP Network
In a TCP/IP network, the CK31G communicates with a host
computer directly using TCP/IP. The access point acts as a
bridge to allow communications between the wired network and
the wireless network.
CK31G Handheld Computer User's Manual