Charging And Installing The Battery - Intermec CK31G User Manual

Chapter 1 — Using the CK31G Handheld Computer

Charging and Installing the Battery

4
The lithium-ion battery pack that is used in this device may
present a fire or chemical burn hazard if it is mistreated. Do
not disassemble it, heat it above 100°C (212°F) or incinerate
it.
Removing the main battery when the backup battery low or
critically low icon displays in the status bar may cause your
CK31G to cold boot and you may lose data.
If you fail to replace the battery immediately, you may lose
important data or applications.
Dispose of used battery packs promptly. Keep away from
children. Contact your local Intermec sales representative for
replacement batteries.
Several factors determine the life of your battery such as extreme
temperatures, input devices, and your usage. For example, if you
use a tethered scanner every day, you will need to replace your
battery more often than someone who uses an internal scanner.
Make sure you fully charge the AB1G battery before you use
your CK31G. You can charge the battery before or after you
install it into the CK31G.
To charge the battery
• Either insert the battery into the AC1 4-slot battery charger
or place the CK31G with battery installed in the AD1 1-Bay
Communications Dock. For more information on these
accessories, see page 100.
Use the next table to understand how long it will take to charge
your batteries in each of the CK31G charging or
communications dock accessories.
CK31G Handheld Computer User's Manual