Intermec CK31G User Manual page 33

CK31G Handheld Computer User's Manual
Chapter 1 — Using the CK31G Handheld Computer
To scan a bar code label with the 2D area imager
1 Press I to turn on the CK31G.
2 Point the scanner window at the bar code label and hold the
CK31G steady a few inches from the label.
3 Press the Scan button on the keypad or pull the trigger on a
handle and center the red aiming beam over the bar code
label.
Scan
button
Scanning: Using the 2D imager to scan a bar code label.
The imager flashes repeatedly while it is trying to read a bar
code. The aiming beam is smaller when the imager is closer to
the bar code and larger when it is further away.
When the CK31G successfully reads a bar code label, you
hear a high beep and the green Good Read light turns on
briefly.
4 Release the Scan button or the trigger.
Good Read
light (green)
* C
C C
E E
M M
R R
E E
T T
N N
I
*
21