Installing And Charging The Battery - Intermec CN2B User Manual

Chapter 1 — Using the CN2B Computer

Installing and Charging the Battery

4
The configuration and time are lost if:
• The battery discharges beyond this level.
• The battery is removed when the computer is not in suspend mode.
• A cold reset is performed on the computer.
You can modify RAM maintenance in a limited way. On the CN2B Com-
puter, tap Start > Settings > the System tab > the Power icon > the Battery
tab. Drag the top slider bar to the right to change the suspend voltage to
favor suspend time over rundown time, then click ok to exit.
Make sure you fully charge the battery before you use your CN2B Com-
puter. To charge the battery, you need to install it in the CN2B Computer.
1 Push down on the battery door latch, pull up on and remove the battery
door, then set it aside.
2 Align the battery contacts, then slide the battery into the compartment.
Press on the battery until it clicks in place, then replace the battery door.
Battery door latch
Battery
CN2B Mobile Computer User's Manual