Deploying The Voip Network; Remote Site Administrator - Multitech MultiVOIP MVP110 Quick Start Manual

Standalone voice/ip gateway

Hide thumbs Also See for MultiVOIP MVP110:

Table of Contents

Deploying the VOIP Network

For a Proprietary Phone Directory database, the VOIP

administrator can deploy the pre-configured slave MVP110s to

their remote sites. The remote site administrators need only

connect power to the pre-configured MVP110, connect the

MVP110 to their Ethernet LAN and predefined telephone

equipment, and then wait for the phone directory database to

be downloaded.

With the Gatekeeper option enabled on the Phone Directory

Database dialog box, all MVP 110s are configured as

"Gatekeeper" and cannot be downloaded. In this case, each

MVP 110 Phone Book will be programmed with phone

numbers for its own channel. These phone numbers are

registered with the H.323 Gatekeeper (See the "Registering

with a Gatekeeper Phone Directory" section discussed earlier.)

The following steps are for MVP 110 H.323 endpoints. For

non-MVP 110 H.323 endpoints, refer to the appropriate

installation documentation.

1. Unpack your MVP 110.

2. Connect one end of the power supply to a live AC outlet

and connect the other end to the Power connection on

your MVP 110 (See Figure 5).

Configuring MultiVOIP Slaves

Table of Contents