Table of Contents
Advertisement
MultiVOIP Quick Start Guide
Voice/Fax Channel
Connection
PHONE
FXS
Figure 5. Remote Site Cable Connection
3. Connect a network cable to the ETHERNET (RJ-45)
connector on the back of your MVP110.
4. If you are connecting a station device such as an analog
telephone, fax machine, or Key Telephone System (KTS)
to your MVP110, connect a phone cable from the phone
connector on the MVP110 to the Phone connector on the
back of the MVP 110 and connect the other end to the
station device.
5. Turn on power to the MVP110 by placing the ON/OFF
switch on the right side panel to the ON position. Wait for
the BOOT LED on the MVP110 to go off before
proceeding. This may take a couple of minutes.
6. At this time your VOIP network should be fully operational.
Dial one of the sites in your network.
46
ETHERNET
POWER
Power Connection
Ethernet Connection
Advertisement
Table of Contents
