Table of Contents
Advertisement
MultiVOIP Quick Start Guide
The default Frame Type is TYPE_II. If this does not match
your IP network, change the Frame Type by selecting
SNAP from the Frame Type list. The available Frame
Type choices are TYPE_II and SNAP.
12. In the Ethernet group, enter the IP Address, Subnet
Mask, and Gateway Address unique to your IP LAN. The
IP address is the unique LAN IP address assigned to the
MVP110. The Gateway address is the IP address of the
device connecting your MVP110 to the Internet. Click OK
when you are finished.
13. The Channel Setup dialog box displays. The four tabs in
this dialog box define the channel interface, voice/fax
parameters, billing/miscellaneous parameters, and
regional telephone parameters.
The Inter Digit Time option defines the maximum amount
of time that the unit will wait before mapping the dialed
digits to an entry in the Phone Directory Database. If too
much time elapses between digits, and the wrong
numbers are mapped, you will hear a rapid busy signal. If
16
Advertisement
Table of Contents
