Table of Contents
Advertisement
MultiVOIP Quick Start Guide
43. When you have finished, click OK to download the default
setup.
44. Click OK. After the setup is written to the MVP110, the
unit reboots.
45. Check to ensure that the BOOT LED on the MVP110 is off
after the download is complete. This may take several
minutes as the MVP110 reboots.
At this time your master MVP110 is configured. Proceed to
the "Configuring Your Slave MVP110s" section.
Configuring Your Slave MVP110s
If the Proprietary Phonebook option on the Phone Directory
Database dialog box was enabled, then you will need to
configure all remote H.323 endpoints as "Slave" units. For
example, the MVP110 at the company's subsidiary office in
London would need to be configured as a "Slave".
CAUTION: If you are installing a MVP110 behind a Firewall,
the Firewall must support H.323. Refer to your Firewall user
documentation to enable H.323 support.
1. Disconnect the PC from the Command port of the Master
MVP110 and connect it to the Command port on the Slave
MVP110.
34
Advertisement
Table of Contents
