Table of Contents
Advertisement
MultiVOIP Quick Start Guide
volume can be increased or decreased. Input gain
modifies the level of the audio coming in to the voice
channel before it is sent over the Internet to the remote
MultiVOIP. Output gain modifies the level of the audio
being output to the device attached to the voice channel.
Make your selections from the Input and Output drop-
down lists in the Voice Gain group. The valid range is
+31dB to –31dB with a recommended/default value of 0.
You can also set up the DTMF gain (or output level in
decibels - dB) for the higher and lower frequency groups
of the DTMF tone pair. Make your selections in the drop-
down lists in the DTMF Gain group. When DTMF Out of
Band is checked, the unit reproduces the DTMF tones
instead of passing them through.
Note: Only change the DTMF gain under the direction of
Multi-Tech Technical Support supervision.
17. To change the voice coder, select the Manual option in
the Coder group. Select the appropriate coder from the
Selected Coder list.
If you changed the voice coder, ensure that the same
voice coder is used on the voice/fax channel you are
calling; otherwise, you will always get a busy signal.
Note: If the Coder is selected automatically,enter the
bandwidth in the Max Bandwidth box. Check with your
Network Administrator to determine how much bandwidth
is available.
18. The Fax group enables you to send/receive faxes on the
voice/fax channel. You can set the maximum baud rate for
faxes, the fax volume, and change the jitter value in
milliseconds.
When receiving fax packets from a remote MVP110, it is
possible for individual packets to be delayed or received
18
Advertisement
Table of Contents
