Installation Sequence - Xantrex XPLORE 120/12 Owner's Manual

Installation Sequence

To make charger installation quick and easy, perform the
installation tasks in the following sequence:
Step 1: Mounting the Battery Charger
n
Step 2: Installing DC Wiring on page 23
n
Step 3: Installing AC Wiring on page 27
n
Step 4: Powering Up on page 29
n
22
Step 1: Mounting the Battery Charger
Mount the XPLORE Charger using all four mounting keyholes of
the mounting brackets. See Mounting flanges on page 23.
Unit mounting orientations shown on page 16 meet IP32 and drip-
proof requirements that are needed to ensure safety in the
presence of condensation. Other possible mounting orientations
will not prevent the entry of dripping water and are not suitable for
use in moist environments.
To mount the XPLORE Charger:
1. Select a mounting surface that is flat and even (see
Mounting Orientations (deck versus wall) on page 23).
2. Mark and pre-drill the top anchors (for dimensions, see
Physical Dimensions [inches(mm)] on page 52.
3. Screw the two anchors on the wall and leave some space
between the screw head and the wall.
4. Hang the XPLORE Charger on the two anchors making
sure the flanges are flush to the wall and the screw heads
are positioned on the narrow side of the key holes.
5. Permanently secure the XPLORE Charger to the wall by
fastening the two top anchors as well driving two additional
anchors through the two round holes on the flanges.
XPLORE 120/12 Battery Charger Owner's Guide