Maintenance And Repair - Otto Bock Dino 3 Instructions For Use Manual

Maintenance and repair

• Have the user get into the product and perform a trial seat fitting. Pay special attention to proper positioning
according to medical considerations.
• In order to ensure that the seat tilt feature operates smoothly, final verification of the seating centre of gravity is
required with the seated user and the designated attendant; adjustments must be made if necessary. The seat­
ing centre of gravity must be set so that the attendant can easily change the angle.
• Attendants and – if possible – the user must be instructed in the safe use of the product. In particular, the
enclosed instructions for use (user) are to be used.
• The instructions for use (user) must be issued to the user or an attendant during handover of the wheelchair.
• The user or attendant should acknowledge that they have been instructed in how to use the product and were
informed of the residual risks.
• Depending on equipment: The supplied instructions for use for accessories have to be handed over in addi­
tion.
9 Maintenance and repair
The manufacturer recommends regular maintenance of the product every 12 months.
Further information on caring for the product and on maintenance/repair can be found in the instructions for use
(user).
Detailed information on repairs can be found in the service manual.
10 Disposal
10.1 Disposal information
All components of the product must be disposed of properly in accordance with the respective national environ­
mental regulations.
10.2 Information on re-use
CAUTION
Used seat padding
Functional and/or hygienic risks due to re-use
► Replace the seat padding if the wheelchair is to be re-used.
The product is suitable for re-use.
Similar to second-hand machines or vehicles, products that are being re-used are subject to increased strain. Fea­
tures and performance must not change in a way that could impair the safety of users or third parties during the
period of use.
The relevant product must be thoroughly cleaned and disinfected before re-use. Then have the product inspected
by qualified personnel with respect to its condition, wear and tear, and damage. Worn and damaged parts as well
as components that do not fit or are unsuitable for the user must be replaced.
Detailed information on replacing components as well as information on the required tools can be found in the ser­
vice manual.
11 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary accordingly.
11.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descriptions and instruc­
tions provided in this document. The manufacturer will not assume liability for damage caused by disregarding the
information in this document, particularly due to improper use or unauthorised modification of the product.
11.2 Warranty
Further information on the warranty terms and conditions is available from the manufacturer's service (see inside
back cover for addresses).
11.3 Service life
Expected lifetime: 4 years
26 Dino 3