Otto Bock Dino 3 Instructions For Use Manual page 28

Appendices
Load depending on equipment
Equipment
Standard equipment
With leg support with single-panel foot plate for seating
shell interface (steel)
With parallel seating shell interface (frame width
360 mm)
With parallel seating shell interface (frame width
400–450 mm)
1)
Varies according to the selected options and model
Permissible tyre pressure for pneumatic tyres
INFORMATION
Note the safety notices regarding air pressure and tyres.
Wheel
Caster wheel
Rear wheel
Drive wheel
1)
Also see print on the tyre wall
Dimensions for different wheel sizes
Dimensions
Min. wheelbase [mm (")]
Max. wheelbase [mm (")]
Max. length including leg support [mm (")]
Overall width [mm (")]
Size 1/frame width: 360 (14.2)
Size 2/frame width: 400 (15.7)
Size 3/frame width: 440 (17.3)
Ambient conditions
Temperatures and relative humidity
Temperature during use [°C (°F)]
Transport and storage temperature [°C (°F)]
Relative humidity [%]
13 Appendices
13.1 Required tools
The following tools are required for adjustments and maintenance work:
• Allen wrenches in sizes 3, 4, 5, 6
• Ring and open-end wrenches in sizes 8, 10, 13, 19 and 24
• Phillips head screwdriver (size: 2)
• Screwdriver (blade width: 3 mm)
• Torque wrench (measurement range 3–50 Nm)
13.2 Torque values of the screw connections
Unless otherwise specified, screw connections are tightened with the following torque values:
• Thread diameter M4: 3 Nm
• Thread diameter M5: 5 Nm
• Thread diameter M6: 10 Nm
28
Maximum load [kg (lbs)]
120 (264)
50 (110)
75 (165)
100 (220)
Wheel size ["] Tyre pressure [bar (kPa; psi)]
7 2.4 (240; 35)
12.5 2.5 (250; 36)
22 4.5 (450; 65)
24 6 (600; 87)
12.5" rear wheel 22" drive wheel
770 (30.3) 800 (31.5)
770 (30.3) 930 (36.6)
830 (32.7) 1,150 (45.3)
540 (21.3) 615 (24.2)
580 (22.8) 655 (25.8)
620 (24.4) 695 (27.4)
-10 to +40 (14 to 104)
-10 to +40 (14 to 104)
45 to 85; non-condensing
1)
24" drive wheel
825 (32.5)
955 (37.6)
1,180 (46.46)
1)
Dino 3