I Distress call
q When receiving a distress call, an emergency
alarm sounds and the display below appears.
w Push [CANCEL/CALL] to stop the alarm, if desired.
• One distress call sequence is sent 5 times repeatedly
within approx. 30 sec. The emergency alarm sounds at
each reception.
e Push [ENT] to set the transceiver to the distress
phone frequency, then monitor the communication
from the coast station to the ship in distress.
I Distress relay call
q When receiving a distress relay call, an emergency
alarm sounds and the display below appears.
w Push [CANCEL/CALL] to stop the alarm, if desired.
e Push [ENT] to set the transceiver to the distress
phone frequency, then monitor the communication
from the coast station to the ship in distress.
WHEN RECEIVING A CALL
r Select the received distress call memory channel
to check the position of the ship in distress.
➥ Push [FREQ/CH] then [RX
" screen.
➥ Select "
[ENT].
➥ Push [ENT] again.
• The received distress call memory is displayed at
the top line with " " symbol.
• When the ship is close to you, communication should
be monitored continuously.
• The traffic frequency is monitored even when the mem-
ory contents is displayed.
r Select the received distress call memory channel
to check the position of the ship in distress.
➥ Push [FREQ/CH] then [RX
" screen.
➥ Select "
" with [CH] then push [ENT].
➥ Push [ENT] again.
• The received distress relay call memory (
) is displayed at the top line with " " symbol.
• When the ship is close to you, communication should
be monitored continuously.
• The traffic frequency is monitored even when the mem-
ory contents is displayed.
8
] to select "
CLAR
" with [CH] then push
] to select "
CLAR
8
39