Icom IC-M802 Instruction Manual page 34

7
CALL PROCEDURE
• When selecting "
e Select "
then push [ENT].
Ç
r Select (or enter) the 9-digit ID code, then push
[ENT].
• Use [CH] to select the ID code when the desired ship's
ID is pre-programmed.
Ç
• Select "
after that, enter the desired 9-digit ID via the keypad.
t Rotate [CH] to select 1st telecommand, then push
[ENT].
✔ When "
step i.
Ç
y Rotate [CH] to select the desired pre-programmed
traffic frequency, or "
[ENT].
✔ When pre-programmed traffic frequency is se-
lected, go to step i.
Ç
26
"
" as the category using [CH],
" with [CH] then push [ENT],
" is selected, go to
" then push
u Enter the desired transmit and receive traffic fre-
quency via the keypad, then push [ENT].
i Rotate [CH] to select the desired calling frequency,
then push [ENT].
Ç
o The calling stand-by screen is displayed as fol-
lows, verify the calling condition then push and
hold [CANCEL/CALL] for 1 sec. to transmit the call.
• Push and hold [ENT] for 1 sec. to store the calling con-
dition into the TX memory described in pages 23 and
43, if desired.
!0 After sending the call, the transceiver waits for an
acknowledgement.