Icom IC-M802 Instruction Manual page 30

7
CALL PROCEDURE
D D Operation for distress call to ships
q Push [DSC] to select DSC watch mode.
w Push [MODE
SET
[DSC]
[CANCEL/CALL]
e Rotate [CH] to select "
[ENT].
r Rotate [CH] to select "
[ENT].
Ç
t Rotate [CH] to select the desired pre-programmed
ID, or "
✔ When pre-programmed ID is selected, go to
step u.
Ç
y Enter the desired 9-digit MMSI code via the keypad.
✔
The number "0 (zero)" cannot be entered for the 1st
digit, as the 1st digit "0" means group code.
u Rotate [CH] to select 1st telecommand, then push
[ENT].
✔ When "
step !0 .
Ç
22
] to select the DSC menu.
[MODE ] [ENT]
SET
[CH] [F] [FREQ/CH]
," then push
," then push
," then push [ENT].
" is selected, go to
i Rotate [CH] to select the desired pre-programmed
traffic frequency, or "
[ENT].
✔ When pre-programmed traffic frequency is se-
lected, go to step !0 .
Ç
o Enter the desired transmit and receive traffic fre-
quency via the keypad, then push [ENT].
!0 Rotate [CH] to select the desired calling frequency,
then push [ENT].
Ç
!1 The call stand-by screen is displayed as follows,
verify the calling condition then push and hold
[CANCEL/CALL] for 1 sec. to start calling.
!2 After the call, wait for an acknowledgement call.
• The calling is performed one time only.
" then push