I Routine Call - Icom IC-M802 Instruction Manual

7
CALL PROCEDURE

I Routine call

When you use DSC for general selective calling, use
"Routine" as the category.
q Push [MODE
SET
w Rotate [CH] to select "
[ENT].
e Select "
then push [ENT].
Ç
r Select the desired 9-digit ID code, then push
[ENT].
• Use [CH] to select the ID code when the desired ship's
ID is pre-programmed.
Ç
• Select "
after that, enter the desired 9-digit ID via the keypad.
t Rotate [CH] to select 1st telecommand, then push
[ENT].
✔ When "
step i.
Ç
32
] to select the DSC menu.
" then push
" as the category using [CH],
" with [CH] then push [ENT],
" is selected, go to
y Rotate [CH] to select the desired pre-programmed
traffic frequency, or "
[ENT].
✔ When pre-programmed traffic frequency is se-
lected, go to step i.
Ç
u Enter the desired transmit and receive traffic fre-
quency via the keypad, then push [ENT].
• One of the voice channels, such as Tx/Rx: 2082.5 kHz,
4146.0 kHz, should be used.
i Rotate [CH] to select the desired pre-programmed
calling frequency, or "
[ENT].
✔ When the pre-programmed call frequency is se-
lected, go to step !0 .
Ç
o Enter the desired transmit and receive call fre-
quency via the keypad, then push [ENT].
" then push
" then push