I Group Call - Icom IC-M802 Instruction Manual

7
CALL PROCEDURE

I Group call

When you use DSC for calling the desired ship's
group, use "Group" menu.
q Push [MODE
SET
w Rotate [CH] to select "
e Select the desired 9-digit group code, then push
[ENT].
• Use [CH] to select the group code when the desired
group is pre-programmed.
Ç
• When "
code (last 8 digits only) via the keypad.
- The first digit "0 (zero)" is fixed for group code.
r Rotate [CH] to select the desired pre-programmed
traffic frequency, or "
[ENT].
✔ When the pre-programmed traffic frequency is
selected, go to step y.
Ç
t Enter the desired transmit and receive traffic fre-
quency via the keypad, then push [ENT].
• One of the voice channel, such as Tx/Rx: 2082.5 kHz,
4146.0 kHz, should be used.
34
] to select the DSC menu.
" then push [ENT].
" is selected, enter the desired
" then push
y Rotate [CH] to select the desired pre-programmed
calling frequency, or "
[ENT].
✔ When the pre-programmed call frequency is se-
lected, go to step i.
Ç
u Enter the desired transmit and receive call fre-
quency via the keypad, then push [ENT].
i The calling stand-by screen is displayed as fol-
lows, verify the calling condition then push and
hold [CANCEL/CALL] for 1 sec. to transmit the
group call.
• Push and hold [ENT] for 1 sec. to store the calling con-
dition into TX memory described in pages 23 and 43, if
desired.
o After sending the call, the traffic frequency is se-
lected automatically.
!0 Announce the following message to stations.
- "The group name."
- "This is ..... (your ship name)."
- The 9-digit identity OR call sign (or other identifi-
cation of the ship).
" then push