D Front Panel Separation; D Front Panel Mounting - Icom IC-7000 Instruction Manual

■ Installation
D Single body mounting
MB-62
(optional)
Supplied with
the MB-62*
Flat washer
*CAUTION: Non-supplied screws (longer than 8 mm)
may damage the internal units.

D Front panel separation

q While pulling the front panel latch towards you,
slide the front panel to the left (fig. 1).
w Attach the optional OPC-1443 to the main body
and tighten the supplied screw as in fig. 2.
e Attach the other end of the OPC-1443 to the de-
tached front panel as in fig. 3.
fig. 1
Latch

D Front panel mounting

q Attach the MB-105 to a flat surface using the four
supplied screws (fig. 1).
w Fix the detached front panel to the MB-105 as il-
lustrated in fig. 2.
BE CAREFUL to mount the MB-105 so that the
front panel attaches with the correct side up.
D Stand
To raise the stand:
Spring washer
With the transceiver upside down, pull the stand to-
Nut
wards the rear panel and then upwards, as illus-
trated below.
fig. 2
Separation cable
(OPC-1443)
INSTALLATION AND CONNECTIONS
then up
Pull back
CAUTION:
NEVER detach/attach the front panel
when connecting the DC power supply (or battery).
Be sure to disconnect the DC power cable from the
[13.8 V] socket on the transceiver rear panel.
fig. 3
Separation cable
(OPC-1443)
fig. 1
2
2
To remove
fig. 2
16