Multi-Function Keys; D Menu M-2 Functions; D Menu M-1 Functions; D Menu M-3 Functions - Icom IC-7000 Instruction Manual

1
PANEL DESCRIPTION

■ Multi-function keys

D Menu M-1 functions

SPL A/B
F-1 F-2
SPLIT OPERATION
➥ Push momentarily to toggle the split func-
SPL
tion ON and OFF. (p. 89)
F-1
• " " and transmit frequency appear when
the split function is ON.
➥ Push and hold for 1 sec. to turn the quick
split function ON. (p. 90)
• The offset frequency must be programmed in
advance using the miscellaneous (others) set
mode. (pgs. 129, 130)
• The offset frequency is the shift from the dis-
played frequency.
• The quick split function can be turned OFF in
the miscellaneous (others) set mode. (p. 129)
VFO A/B SELECTION
➥ Push momentarily to exchange the trans-
A/B
mit VFO and receive VFO contents. (p.
27)
F-2
➥ Push momentarily to toggle the transmis-
sion VFO and reception VFO during split
operation. (p. 89)
➥ Push momentarily to toggle the transmit
and receive frequencies (and modes) of
memory channels when the split function
is turned ON.
➥ Push and hold for 1 sec. to equalize the
frequency and operating mode of the two
VFO's.
• The lower indicated frequency and operating
mode are equalized to the upper (indicated)
VFO frequency and operating mode.
FILTER SELECTION (p. 75)
➥ Push momentarily to select one of three
FIL
IF filter settings.
F-3
➥ Push and hold for 1 sec. to enter the filter
set mode.
TRANSMIT FREQUENCY CHECK (pgs. 65, 89)
XFC Monitors the transmit frequency when
pushed and held.
F-4
• While pushing and holding this key, the trans-
mit frequency can be changed with [DIAL].
5
FIL XFC
F-3 F-4

D Menu M-2 functions

MEM MW
F-1 F-2
MEMORY MENU (p. 103)
Push momentarily to indicate the memory
MEM
frequency and modes.
F-1 • Memory list indication is available.
MEMORY WRITE (pgs. 101, 102)
MW Push and hold for 1 sec. to store the se-
lected frequency and operating mode into
F-2
the displayed memory channel.
MEMORY CLEAR (p. 106)
Push and hold for 1 sec. to clear the se-
MCL
lected memory channel contents.
F-3
• " " appears.
VFO/MEMORY SELECTION
➥ Push momentarily to toggle VFO and
V/M
memory modes. (pgs. 27, 100)
➥ Push and hold for 1 sec. to transfer the
F-4
selected memory channel to the currently
displayed VFO. (p. 107)

D Menu M-3 functions

DURING SSB OPERATION:
VOX COM
F-1 F-2
DURING CW OPERATION:
BRK 1/4
F-1 F-2
DURING RTTY OPERATION:
1/4
F-1 F-2
DURING AM OPERATION:
VOX
F-1 F-2
MCL V/M
F-3 F-4
AGC TBW
F-3 F-4
AGC
F-3 F-4
AGC
F-3 F-4
AGC
F-3 F-4