Scan Operation; Scan Types - Icom IC-7000 Instruction Manual

9

SCAN OPERATION

■ Scan types

PROGRAMMED SCAN
Repeatedly scans between two scan edge frequencies
(scan edge memory channels 1A and 1B).
Scan edge 1A or 1B
This scan operates in VFO mode.
MEMORY SCAN
Repeatedly scans all programmed memory channels.
Mch 2
ß (select)
Mch 1
Mch 99
ß (select)
This scan operates in memory mode.
■ Preparation
• Channels
For programmed scan: Program scan edge frequen-
cies into scan edge memory channels 1A and 1B.
(p. 101)
For memory scan: Program two or more memory
channels except scan edge memory channels.
For memory select scan: Designate two or more mem-
ory channels as select memory channels—select a
memory channel, then push [F-2 S S E E L L ] in the S S - - 2 2
menu (memory mode) to designate the channel as a
select memory channel.
For priority watch: Program one memory channel to be
watched.
• Scan resume ON/OFF
You can select the scan to resume or cancel when de-
tecting a signal, in the miscellaneous (others) set
mode, item "S S C C A A N N R R e e s s u u m m e e ." Scan resume ON/OFF
must be set before operating a scan. See p. 132 for
ON/OFF setting and scan resume condition details.
Scan speed
•
Scan speed can be selected from 2 levels, high or low,
in the miscellaneous (others) set mode. See p. 132 for
details.
111
Scan
Scan edge 1B or 1A
Jump
BLANK
ß (select)
Mch 3 Mch 4
ß (select)
Mch 5
Mch 7 Mch 6
ß (select)
PRIORITY WATCH
Checks for signals on a memory while operating on a
VFO frequency.
VFO
frequency
This scan operates in VFO mode.
SELECTED MEMORY SCAN
Repeatedly scans all selected memory channels.
ß (select)
Mch 2 Mch 3
Mch 1 ß (select)
Mch 99 Mch 7
ß (select) ß (select)
This scan operates in memory mode.
• Squelch condition
SCAN
PROGRAMMED
STARTS
SCAN
WITH
The scan continues
until it is stopped man-
ually, and does not
pause even if it de-
tects signals.
SQUELCH
This is not applicable
OPEN
when the scan re-
sume is OFF and a
programmable
(more than 1 kHz) is
selected.
Scan stops when detecting a signal.
If you set scan resume ON in the miscella-
SQUELCH
neous (others)l set mode, the scan pauses for
CLOSED
10 sec. when detecting a signal, then re-
sumes. When a signal disappears while scan
is paused, scan resumes 2 sec. later.
Memory
channel
BLANK
Mch 4
ß (select) Mch 5
Mch 6
MEMORY SCANS
PRIORITY WATCH
Scan pauses on each
channel when the
scan resume is ON;
not applicable when
OFF.
step