Icom IC-7000 Instruction Manual page 50

4
RECEIVE AND TRANSMIT
■ Operating CW
q Connect a paddle or straight key as on page 22.
w Push [Y Y ( )]/[Z Z (
BAND
band or push a band key on the HM-151.
e Push [MODE] momentarily to select CW mode.
• After CW mode is selected, push and hold [MODE] for
1 sec. to toggle between CW and CW-R modes.
r Rotate [DIAL] to tune in a desired signal with the
desired tone frequency.
t Rotate [AF] to set audio to a comfortable listening
level.
y Set CW break-in operation as semi break-in, full
break-in or OFF.
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group M M .
• Push [MENU/GRP] momentarily one or more times to
select the menu M M - - 3 3 .
• Push [F-1 B B R R K K ] one or more times to select the CW
break-in operation.
• " ," " ," and "OFF (no indication)" appears.
➧ BK-IN : semi break-in
➧ F-BK : full break-in
➧ OFF : no break-in (ACC socket connection is neces-
sary as shown on page 22.)
u Set the CW delay time when semi break-in opera-
tion is selected.
• Push and hold [F-1 B B R R K K ] for 1 sec. to enter the break-
in delay time set mode.
• Rotate [DIAL] to set the desired delay time.
i Set CW setting in the keyer set mode (S S - - 1 1 ).
• Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group S S .
• Push [MENU/GRP] momentarily one or more times to
select the menu S S - - 1 1 .
• Push [F-2 K K E E Y Y ], [Z Z (
enter the keyer set mode. (p. 49)
o Keying to transmit, use the electric keyer or paddle
to send your CW signals.
• [TX] indicator lights red.
• The Po meter indicates transmitted CW signal strength.
!0 Stop keying to return to receive.
41
)] to select the desired
BAND
)], then [F-4 S S E E T T ] to
/
MENU GRP
[AF] [MODE] [TX] indicator
[MENU/GRP] [F-1] [F-2] [F-4]
"CW" or "CW-R" appears
Appears
Semi break-in operation is selected.
Delay time of 7.5 dots is selected
for semi break-in operation.
[Y]
[Z]
[DIAL]