Select Memory Scan Operation; Priority Watch - Icom IC-7000 Instruction Manual

Hf/vhf/uhf all mode transceiver
Hide thumbs Also See for IC-7000:
Table of Contents

Advertisement

9
SCAN OPERATION

■ Select memory scan operation

q Select S S - - 2 2 .
w Push [F-3 V V / / M M ] to select memory mode.
e Close the squelch with [RF/SQL].
r Push [F-1 S S C C N N ] to start the memory scan.
• Decimal point blinks while scanning.
t Push [F-2 S S E E L L ] to change the memory scan to se-
lect memory scan.
y When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
u To cancel the scan push [F-1 S S C C N N ].
NOTE: Two or more memory channels must be
designated as select memory channels for select
memory scan to start (see p. 104).
While scan function is not active, pushing [F-2
S S E E L L ] sets the select memory channels ON or OFF.
And pushing and holding [F-2 S S E E L L ] for 2 sec.
clears the all select memory channels.

■ Priority watch

q Select VFO mode, then set a frequency.
w Close the squelch with [RF/SQL].
e Set the desired memory channel as the channel to
be watched.
r Select S S - - 2 2 .
t Push [F-2 P P R R I I ] to start the priority watch.
• " " appears and decimal points blink while watching
VFO, and then " " and decimal points blink while
watching a memory channel.
y When the scan detects a signal, the scan pauses
for 10 sec. or until the signal disappears, depend-
ing on the resume setting.
u To cancel the scan push [F-2 P P R R I I ].
NOTE: The paused condition when detecting a sig-
nal differs depending on the scan resume condi-
tion. (p. 132)
resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.
113
Menu group selection
Push [MENU/GRP] for 1 sec.
Selection from: M M , S S or G G (Graphic)
Menu selection (Example: M)
Push [MENU/GRP] momentarily.
Selection from: S S - - 1 1 , S S - - 2 2 or S S - - 3 3
[RF/SQL]
[MENU/GRP] [F-1] [F-2] [F-3]
Push [F-1 SCN],
then push [F-2 SEL].
[RF/SQL]
[MENU/GRP] [F-2]
Push [F-2 PRI].
Either
Either
Y or Z
Y
Z
or
Select
memory mode.
Designate
"★."
Appears while scanning
Select
VFO mode.
Select watching
channel.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents