Troubleshooting - Fisher & Paykel DH8060P3 User Manual

The following is a list of problems you may encounter when using this appliance and some
suggestions that may help to correct the problem. If you still have problems, contact your
Fisher & Paykel trained and supported service technician.
PROBLEM
Pressing
POWER
does
not turn on
the dryer
Dryer does
not heat
Pressing
does not start
the drying cycle
Dryer keeps
stopping
and starting
Dryer stops
working
mid-cycle

TROUBLESHOOTING

POSSIBLE CAUSES
Fault with household
power supply.
Full water tank.
The dryer has progressed
to .
COOL
Dryer door not closed
properly.
Is the dryer displaying a user
warning or fault code?
Water tank full or not
properly in place.
Dryer is overloaded.
function is set.
DELAY START
is ON.
KEYLOCK
The
WRINKLE FREE
has been selected.
Power failure.
Dryer has been paused.
Dryer door is open.
Items fell off the rack
when using
RACK DRY
WHAT TO DO
Try plugging in and turning on another
electrical device.
Refer to 'Emptying the water
collection tank'.
Check the progress lights – are
or
COOL
Refer to 'Control panel'.
Open and close the door. Check that the
lint filter is correctly in place and not
obstructing the door.
Refer to 'User warnings' and 'Fault codes'.
Refer to 'Emptying the water collection
tank'. Ensure the water tank is properly
in place.
Remove some items from the dryer.
Refer to 'Delay Start' for more
information.
To disable press
option
Refer to '
information.
Press
desired cycle.
Press
Ensure the door is firmly shut.
Ensure the rack is installed correctly
cycles. (refer to 'Drying rack') and replace
garments that may have fallen from it.
lights illuminated?
END
for two seconds.
Wrinkle Free
' for more
and restart the
POWER
to restart the cycle.
39