Fisher & Paykel DH8060P3 User Manual page 42

PROBLEM
Noises
Vibration
Creasing
42
TROUBLESHOOTING
POSSIBLE CAUSES
Dryer is overloaded.
Dryer has a fault.
Beeps signalling the end
of a drying cycle.
Dryer has not been
levelled properly.
Dryer makes unfamiliar noises.
Dryer is not installed on
a stable surface.
Dryer is not level.
Dryer is overloaded.
Cycle selection not
appropriate for the load.
Dryer is overloaded.
selected
DRYNESS LEVEL
too high for load type.
option
WRINKLE FREE
not selected.
WHAT TO DO
Remove some items from the dryer.
Continuous beeping or a musical
series of beeps with a message
displayed on the display.
Refer to 'Fault codes'.
End of cycle beeps can be turned off
refer to 'customising drying cycle'.
Refer to 'Levelling the dryer'.
At the start of the cycle the dryer may
make some unfamiliar noises when the
compressor turns on. This is normal.
Ensure the dryer is installed on a flat,
stable surface. Refer to 'Levelling
the dryer'.
Ensure the dryer is correctly levelled.
Refer to 'Levelling the dryer'.
Remove some items from the dryer.
Select the
EASY IRON
minimise creasing.
Remove some items from the dryer.
Try selecting a lower
Select the
WRINKLE FREE
rotate the load at the end of the
drying cycle. Refer to 'Wrinkle Free'.
cycle to
.
DRYNESS LEVEL
option to