Fisher & Paykel DH8060P3 User Manual page 14

Completing the installation
Test cycle
Ensure the test cycle is completed before you dry any items in your dryer. The test cycle is
to check that your dryer is installed correctly and that it is functioning properly prior to use.
1
2
3
If there are any problems, you must address these before proceeding with normal use. The
dryer will automatically turn off at the end of the cycle if there are no problems.
14
INSTALLATION INSTRUCTIONS
Press to activate your dryer.
POWER
Select the
TIME DRY
Ensure the drum is empty and the door
is closed (you will hear it click shut).
Press , the drum will start rotating.
Observe the dryer for any problems.
The dryer will beep and display any faults on
the screen if there are any problems, refer to
'Before you call for service', 'User warnings'.
At the completion of the cycle, open
the door and check that there is warmth
inside the dryer. This indicates the dryer is
operating normally.
cycle for 30 minutes.