Troubleshooting - Fisher & Paykel DE8060P Installation Manual/User Manual

The following is a list of problems you may encounter when using this appliance and some
suggestions that may help to correct the problem. If you still have problems, please contact
your Fisher & Paykel trained and supported service technician.
PROBLEM
Pressing
POWER
does not turn
on the dryer.
Dryer does
not heat.
Touching does
not start the
drying cycle.

TROUBLESHOOTING

POSSIBLE CAUSES
Electrical cord not plugged into
a power socket.
Power switch not switched on.
Fault with household
power supply.
Dryer set to
COOL AIR
Full water tank.
The dryer has progressed
to .
COOL
not touched firmly enough.
Dryer is paused.
Dryer door not closed properly.
Is the dryer displaying a user
warning or fault code?
Water tank full or not properly
in place.
Lint filter needs to be emptied.
Dryer is overloaded.
function is set.
DELAY START
WHAT TO DO
Plug cord into a power socket.
Switch power on.
Try plugging another electrical
appliance into the same socket. Turn
off the power at the power point.
Unplug the dryer from the power
socket. Wait 60 seconds, plug it back
in, turn it on and try again.
cycle. Check what cycle the dryer is set to.
Refer to 'Drying cycles'. Change to
preferred cycle.
Empty the water tank. Refer to 'Caring
for your dryer'.
Check the progress lights– are
or
COOL
Refer to 'Control panel'.
Touch
light will be flashing. Touch
resume the cycle.
Open and reclose the door.
Refer to 'User warnings' and
'Fault codes'.
Empty the water tank. Refer to 'Caring
for your dryer'. Ensure the water tank
is properly in place.
Empty the lint filter and ensure it is
correctly in place.
Remove some items from the dryer.
Refer to
more information.
lights illuminated?
END
again.
for
'DELAY START'
to
37